After passing the test, they are lined up on the table of inspection. Then inspect 100% one by one. We check the next.

We can paint equally by inserting blanks into the hole of rubber seal and pulling out.

The carbon material is preserved in coolerator (0 degree) and freezer (-20 degree). (due to storage period)

TCut the carbon as per each paper patterns.

Bond it to the mandrel by iron.

Then roll it by rolling machine.And the strength of rolling is set model by model.

Wrap the tape round blanks by taping machine. And it should be appropriate level of power.

Burn the taped blanks by setup temperature and time.

Put them and cushion material into the box.And put the sticker of model number & box no.

Only passing products put into rod bag.

This work demends the proficient skills.

Cut in regulation size.

Sand the blanks by regulation method.

Centerless

String test: check the level of weight which each rods correspond to.

Spray-paint

Coat the thread of guide with epoxy while spinning. Then the epoxy attach equally by spinning the blanks.

Then send to epoxy section.

Wrap each guides by the specified color thread on the specified position.

Attach the sticker on the specified position and send to epoxy section.

Set up each equipments (EVA handle, reel seat, metal parts & etc..) by bond.